877-566-5369 sales@koolmat.com

FOILS

REFLECT 90° RADIANT HEAT

Foil description here

1503-28 SILVER REFLECTIVE FILM

28” x 12” – silver

This silver reflective film reflects at least 95% of the radiant energy. This film provides radiant heat protection up to 1050˚F and higher for short durations. There is at least a 400˚F gradient temperature drop across the 10 mil thick film during normal operating temperatures.

The film 14 mil thick (0.014 inches) weighs about 12 oz sq yd²

This film has a fire resistant pressure sensitive adhesive that incorporates a fiberglass woven fabric for strength and tear resistance. The peel strength of the adhesive is about 10# / inch when pulled at 180 degrees.

This film meets or exceeds the FAA 12-second vertical burn requirement.

10303-28 GOLD REFLECTIVE FILM

24” x 12” – gold

This gold reflective film reflects up to 750˚F of radiant heat and has a heat soak / continuous operating temperature of 450˚F. There is up to a 70˚F gradient temperature drop across the 6 mil thick film during normal operating temperatures.

The film weighs about 5 ounces per square yard.

This film has a fire resistant pressure sensitive adhesive that incorporates a fiberglass backing for strength and has tear resistance. The Peel strength is about 10# / inch when pulled at 180 degrees.

This film meets or exceeds the FAA 12-second vertical burn requirement.

NEW! OEM TYPE HEAT/SOUND INSULATION

HEAT/SOUND INSULATION description here

 #04248 ZERO CLEARANCE / PSA

42″ x 48″ – foil/psa

Zero Clearance is a diamond faced 3-piece high-tech heat & sound barrier material used on the firewall engine side or under the vehicle on floor/tunnel or exhaust to stop heat. Stop heat before it enters the driver’s compartment. Great for racecars!

The Zero Clearance material’s foil side is a 10-mil aluminum facing designed to reflect heat and it is bonded to a 3/16-inch layer of composite fiberglass insulation with a PSA glue added to underneath for faster installation. Material is rolled for easy shipping. Seal edges for outside weather with silicone….

Some products work well together like a Buddy system. Using Koolmat on the inside interior floor, firewall, tunnel and Zero Clearance on the inside of the sides of the tunnel, under tunnel top will prevent heat from entering the interior stopping heat.

 

#FGS-125 SPLIT FOIL – FOIL / GLASS / PSA

24″ x 51″ – foil/gl/psa

GOOD TO 1000 DEGREE F.

Great for Hi Temperature areas like racing engine firewalls & street rods or restoration in headliners.

Size; ea panel is 24” x 51”x 1/8” thick with a psa on the back for easy install.       

Cut each panel to fit the section you’re working on. Then peel away the backing and place on the object you want to insulate.  When the foil is placed into the engine area or the headliner area butt the edges together. This will stop heat from penetrating through to the inside of the vehicle and will reflect too!

Great for cutting patterns, make a pattern, lay the design on the foil so that the sticky side is down. Cut the pattern and peel off the backing and insulate your part. Easy to do in minutes!

#09029 SEAM FOIL TAPE – SEALS SPLIT FOIL EDGES

2″ x 12″ – foil/psa

2” sticky silver tape to seal cracks where you butted sheets together- tape sold per foot